Skip to content
You're reading the docs for Railroader 0.6 (the MoW Update), currently available on the Experimental branch.

Ops: Passenger

Stations and lines define your map’s passenger service. A station is a named place with a timetable code, and a line is an ordered list of stations. You’ll find both under Ops: Passenger in the outline, and create them from the Ops group of the create menu.

A station is either a passenger stop or a timing point. A passenger stop belongs to an industry and boards and unloads passengers on its track spans. A timing point has no industry and no passengers; it only gives the timetable a place to list. The Passenger Stop toggle switches a station between the two.

Stations have the following properties:

PropertyMeaning and constraints
IdThe station’s identifier on the map. Can’t contain --.
CodeThe timetable code. Letters only, required, unique on the map. Example: BR for Bryson. Saved player timetables refer to stations by code, so changing one breaks those references.
NameThe station’s name, shown in timetables, on coaches, and in the station agent’s window. Elsewhere, such as the Locations panel, a passenger stop appears under its industry’s name.
Passenger StopOn makes the station a passenger stop. Off makes it a timing point.

Passenger stops add these properties:

PropertyMeaning and constraints
IndustryThe industry the stop belongs to. Sets where the stop appears in the Locations panel and which ops area it’s in. Required.
Track SpansThe track in front of the station. Passengers board and unload when a coach stops on one of these spans, along with the coaches coupled to it. At least one is required.
Base PopulationThe stop’s baseline passenger demand. The base game map uses 5 for a junction with little around it and 50 for the largest towns on the line.

A passenger stop generates passengers only while progression has enabled it and at least one of its track spans connects to an enabled interchange. The editor warns you if your map has passenger stops but no interchange.

A line lists its stations east to west, each one once, and needs at least two. The editor flags a station that’s on no line, since passengers can’t travel to or from it.

PropertyMeaning and constraints
IdThe line’s name on the map.
NameThe name shown for the line’s timetable section.
OrderRanks the lines. The lowest value is the main line and every other line is a branch. Two lines can’t share the lowest value.
StationsThe ordered station list. Each entry except the last has a Seconds to next value, the travel time to the following station.

Seconds to next feeds the timetable. The running time between two stations on the same line is the sum of these values along the line, rounded up to whole minutes. The slow running time is 20% longer than the fast one.

A branch must start or end at a passenger stop on the main line and share no other station with it. That shared station is the junction, and each junction serves one branch.

Railroader builds two things from your lines:

  • The passenger route network. Each passenger stop connects to its neighboring passenger stops on a line, skipping timing points, so passengers travel along lines.
  • The timetable. Each line gets a section listing every station on it, timing points included.

The editor also warns when two consecutive passenger stops on a line have no track between them. It flags a broken rule from this page in the outline and in the station’s or line’s inspector, and the game lists the same problems in the Message Log when the map loads.

Maps made before stations and lines existed, with passenger stops inside industries and a timetable of branches, convert automatically when they load.